XIB-E【PDF 11/64 页】BOARD INTERFACE ETHERNET

7页 8页 9页 10页 [11页]12页 13页 14页 15页

XStream"燨EM燫F燤odule?燩roduct燤anual爒5.x00燵2006.02.24]?/DIV>

2.2. Modes of Operation

XStream OEM RF Modules operate in five modes.

Figure?04. XStream燤odes爋f燨peration?/DIV>

The爉odule燾an爋nly燽e爄n爋ne爉ode燼t燼爐ime.?/DIV>

2.2.1. Idle Mode

When not receiving or transmitting data, the module is in Idle Mode. The module uses the same

amount of power in Idle Mode as it does in Receive Mode.

The module shifts into the other modes of operation under the following conditions:

" Serial data is received in the DI Buffer (Transmit Mode)

" Valid RF data is received through the antenna (Receive Mode)

" Command Mode Sequence is issued (Command Mode)

" Sleep Mode condition is met (Sleep Mode)

After responding to any of the preceding conditions, the module automatically transitions back

into Idle Mode.

2.2.2. Transmit Mode

After the first byte of serial data is received in the DI buffer (from the UART), the module

attempts to shift to Transmit Mode and initiate RF connections with other modules. After

transmission is complete, the module returns to Idle Mode.

RF transmission begins after either of the following criteria is met:

1. RB bytes have been received in the DI buffer and are pending for RF transmission [refer to

RB (Packetization Threshold) Command, p29].

The RB parameter may be set to any value between 1 and the RF packet size (PK), inclusive.

When RB = 0, the packetization threshold is ignored.

2. At least one character has been received in the DI buffer (pending for RF transmission) and

RO time has been observed on the UART [refer to RO (Packetization Timeout) Command].

The timeout can be disabled by setting RO to zero. In this case, transmission will begin after

RB bytes have been received in the DI buffer.

After either RB or RO conditions are met, the module then initializes a communications channel.

[Channel Initialization is the process of sending an RF initializer that synchronizes receiving

modules with the transmitting module. During channel initialization, incoming serial data

accumulates in the DI buffer.]

Serial data in the DI buffer is grouped into RF packets [refer to PK (RF Packet Size)]; converted

to RF data; then transmitted over-the-air until the DI buffer is empty.

RF data, which includes the payload data, follows the RF initializer. The payload includes up to

the maximum packet size (PK Command) bytes. As the transmitting module nears the end of the

transmission, it inspects the DI buffer to see if more data exists to be transmitted. This could be

the case if more than PK bytes were originally pending in the DI buffer or if more bytes arrived

from the UART after the transmission began. If more data is pending, the transmitting module

assembles a subsequent packet for transmission.

Note: RF reception must

complete before the

module is able to enter

into Transmit Mode.

牋牘?006燤axStream,營nc.燙onfidential燼nd燩roprietary?/DIV>

11?/DIV>

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式